Impala FAQs

We refer to the tubes and their positions in the amp as V1, V2, etc. for preamp tubes and P1, P2, etc. for power tubes. The number indicates the position of the tube as counted from right to left when looking at the back of the amplifier. The right to left progression follows the circuit from input to output.

 

ImpalaTubes
  P2 P1 V4 V3 V2 V1
Type 6L6WGS
 
6L6WGS
 
12AT7 5751 or  (12AX7 okay) 12AT7EH 12AX7EH
Manufacturer TAD TAD Electro-Harmonix 5751 - TAD or
12AX7-Electro-Harmonix
Electro-Harmonix
Function 1/2 Push-pull power stage 1/2 Push-pull power stage Phase inverter and tremolo oscillator Reverb return and mix Reverb send Initial gain stage, post tone-stack recovery

.stages

The Impala is a fixed bias amplifier and requires a bias adjustment whenever the power tubes are changed. See the Impala Owner's Manual for more information on adjusting the bias.

 

Please use well-matched pairs of power tubes for maximum performance and minimum hum in triode mode.The Impala can only use matched pairs of 6L6, 5881, or 7581A power tubes.

Carr Amplifiers selects and tests the finest current production tubes specifically for each amplifier model. Caution should be used when buying replacement tubes from any dealer who does not have a return policy as all tubes can have problems (NOS tubes are susceptible to microphonics and failure too).

Top of Page